How to Add a Left Margin for Printing and Binding in Acrobat
Question details
The user needs to add extra blank space along the left edge of a PDF document to accommodate hole punching or physical binding.

- Product
- Adobe Acrobat
- Device & OS
- not provided
- Scenario
- Preparing a digital PDF document for physical printing where specific margin spaces are required to prevent text from being cut off by bindings.
- Observed behavior
- The current document lacks sufficient left margin space, meaning the content is too close to the left edge for proper hole punching or binding.
Before adjusting the page margins, ensure your document's text and layout are fully finalized, as modifying the page boundaries is best done as the very last step before sending the file to the printer.
Adjust Left Margin Using Acrobat's Crop Pages Tool
Increase the page's overall size and shift the content to create a designated left margin for binding without altering the original text flow.
In Adobe Acrobat, you cannot directly change word-processor margins like you do in Microsoft Word. Instead, you modify the 'Page Boxes' (specifically the CropBox or MediaBox) to expand the canvas size and add extra blank space precisely where you need it.
Open your document in Adobe Acrobat. Click on the 'Tools' tab at the top of the window, and select 'Edit PDF'.
In the secondary toolbar that appears, click on 'Crop Pages'. Your cursor will turn into a crosshair.
Double-click anywhere on the current document page. This action will open the 'Set Page Boxes' dialog window where margin controls are located.
Look for the 'Change Page Size' section at the bottom. Select 'Custom' and increase the Width to accommodate your binding margin (e.g., add 1 inch to the total width). Adjust the 'XOffset' value to shift the original content to the right, leaving the new blank space strictly on the left side.
In the 'Page Range' section located in the bottom right corner, select 'All' to ensure the binding margin is applied to every page uniformly, then click 'OK'.

Easily Adjust PDF Page Margins with WPS Office
WPS Office provides an intuitive, lightweight PDF editor equipped with comprehensive page management tools. You can effortlessly adjust page sizes, add binding margins, and prepare your documents for high-quality professional printing.
- 1. Open Your PDF: Launch WPS Office and open the PDF file you intend to print.
- 2. Navigate to Page Edit: Select the 'Page' tab from the top ribbon to access page layout and formatting tools.
- 3. Modify Page Margins: Use the 'Page Setup' or canvas adjustment tools to specifically increase the left-hand margin space for your binding requirements.
- 4. Preview and Print: Click 'Print' to open the preview dialog, verify that the left margin is clear of text, and proceed with printing.

Frequently Asked Questions
How much left margin space should I leave for standard binding?
For standard 3-hole punching, spiral binding, or comb binding, it is typically recommended to leave a left margin of 0.5 to 1 inch (12.7 to 25.4 mm). Check with your specific binding machine or print shop for precise requirements.
Will adding a margin in Acrobat scale down my text size?
When using the Set Page Boxes tool to expand the canvas, your text size remains exactly the same; the page itself just gets larger. However, if you later select 'Fit to Printable Area' in your Print dialog, the printer driver might scale the entire page down slightly to fit physical paper constraints.
Is it better to add margins in the source document or the PDF?
It is always best to set the correct binding margins (often called gutter margins) in the original source document like Microsoft Word or WPS Writer before exporting to PDF. Adjusting the PDF should be a fallback method if the source file is no longer available.




