How to Fold Letters for No. 10 Window Envelopes in Word
Question details
The user wants to position an address and fold a letter so the address shows through a No. 10 window envelope, then save the layout for reuse.

- Product
- Microsoft Word
- Device & OS
- not provided
- Scenario
- Create a reusable letter layout for a specific No. 10 window envelope.
- Observed behavior
- The recipient address should remain fully visible through the envelope window after the letter is folded and inserted.
Have the actual envelopes and US Letter paper available. Window positions vary, so measure your envelope's window rather than relying on a standard address position.
Test the Address Position and Save a Word Template
Use the actual envelope to verify the folds and address placement before saving the letter layout.
In Word, open the letter and select Layout > Size > Letter (8.5 × 11 inches). Enter the recipient address as a separate block.
Measure the window's distance from the envelope's top and left edges, as well as its height and width. Use View > Ruler and the paragraph or margin controls to position the address approximately where the folded letter will meet the window.
Select File > Print and print at actual size. Fold the bottom third of the 11-inch sheet upward, then fold the top third down, making folds about 3⅔ inches apart. Insert the letter with the address facing the window; adjust the fold order if your envelope requires it.
Look through the window and move the letter within the envelope to check that every address line stays visible. If needed, change the address position in Word and repeat File > Print with another test page.
Replace the test address with placeholder text. Select File > Save As and choose Word Template (*.dotx) to create a reusable template.

Prepare Window Envelope Letters in WPS Writer
Use WPS Writer to position the address, print and test the folds, and keep a reusable letter layout for your envelopes.
- 1. Open the letter: In WPS Writer, open your existing DOCX letter or create a new document.
- 2. Set up the page: Use Page Layout > Size to select Letter paper, then enter and position the recipient address using the ruler and paragraph controls.
- 3. Print and test: Select File > Print and print at actual size. Fold the sheet into thirds, insert it into the envelope, and check that the complete address shows through the window.
- 4. Save a reusable copy: Adjust the address position if needed, then use File > Save As to save the tested layout. Choose a template format if available, or save a DOCX master and make a new copy for each letter.

Frequently Asked Questions
Where should the address go on a letter for a window envelope?
Measure the window on your actual envelope and position the address so it aligns after folding. Print a test page, insert it, and adjust the address until all lines remain visible.
How do I fold a letter into thirds for a No. 10 envelope?
For an 11-inch-long Letter sheet, fold the bottom third upward and then the top third down, with folds about 3⅔ inches apart. Insert it with the address facing the window and check the result.
Can Word show exactly where the envelope window will appear?
File > Print previews the page, but it does not verify how the folded letter sits inside your particular envelope. Print and insert a test letter to check the window alignment.
How do I reuse the finished layout in Word?
Replace the test address with placeholder text, then select File > Save As and choose Word Template (*.dotx). Use the template to create future letters without changing the master layout.




